Tilting Furnace KC and Bale-Out Furnace TC

Tilting Furnace KC and Bale-Out Furnace TC
SiC-Rod-Heated, for Melting

The electrically heated tilting and bale-out furnaces of the KC and TC product lines are characterized by a higher melting performance than achievable with wire heated melting furnaces. These furnaces are designed for permanent operation at working temperatures.

Tmax 1450 °C, also suitable for bronze alloys with a maximum melt temperature of up to 1320 °C, subject to the condition of crucible
    Heating from two sides by generously dimensioned SiC rods, temperature uniformity
    Simple exchange of individual heating elements
    Heat operation by thyistors in phase-angle mode with performance control:
The resistance of the SiC rods changes with temperature and age. Performance control ensures constant power of heating irrespective to the condition of the heating elements.
    High melting performance with temperature uniformity
    Insulation constructed in multiple layers with lightweight refractory bricks on the hot face
    SiC-Crucible
    Electro-hydraulic tilting system with flame resistant HFC hydraulic fluid (KC models)
    Safe, even, and precise pouring thanks to optimum pivot point in the furnace and manual throttling valve operation (KC models)
    Emergency outlet for safe draining of the melt in case of crucible breakage
    No exhaust gas discharge needed
    Over-temperature limiter in furnace chamber for protection against overheating. The limiter switches the heating off when the set limit temperature is reached, and only switches it back on after the temperature has fallen again
    Furnace chamber control with temperature measurement behind the crucible
    For Information on temperature regulation see page 24